K1pp & R4 - Powerspark Electronic Ignition Kit (Positive Earth) for Lucas 22D6 & 25D6 Distributor
This Powerspark Electronic Ignition Kit is designed to replace the points and condenser inside a Lucas 22D6 & 25D6 Distributor.
The Lucas 22D6 & 25D6 Distributor was fitted to a wide variety of 6 Cyl vehicles including Aston Martin, Austin Healey, Jaguar, Land Rover, MG, Triumph, TVR and many more.
It is a complete kit to convert your car to electronic ignition, including a Powermax moulded Red Rotor Arm. Fitting is easy and instructions are included with the packaging, as well as available online.
Electronic ignition will give your classic car better starting and smoother running.
Please Note - This Powerspark Electronic Ignition Kit is for positive earth vehicles only.
This Powerspark Electronic Ignition Kit contains everything needed to convert your car from points & condenser to electronic ignition.
Fitting is easy and instructions are included with the packaging, as well as available online and in the video below.
- Easy to install
- Replaces troublesome points and condenser
- No visible difference in your engine bay
- Improved starting
- Improved performance
- Improved durability
- Maintenance free
- To be used with a coil resistance above 1.5 ohms only
- MUST be used with silicone HT leads, NOT COPPER. Click here to browse our range of HT leads.
Powerspark Electronic Ignition explained in more detail:
The kit uses a simple magnetic trigger and optimises dwell to provide a reliable and consistent spark across the rev range. It is easy to install and maintenance free.
Each kit comprises a baseplate with electronic module, trigger ring and all wiring. The new electronic baseplate mounts exactly where the points and condenser baseplate sat. The kit connects directly to the coil using the wires provided, red to the positive side and black to the negative side. The ignition kit will automatically shut down if the ignition is left switched on without the engine running to prevent component damage.
Powerspark Electronic Ignition Kits are designed to work with a coil resistance above 1.5 ohms, typically 3.0 ohms. Some performance coils operate at a lower resistance and will need the High Energy electronic ignition kit.
Full fitting instructions are included with your kit, and plenty more instructions can be found on our blog.
Watch our 'how to fit a Powerspark Electronic Ignition Kit' video here:
2 Reviews Hide Reviews Show Reviews
Works Fine - But needs extra insulation and cable guidance to ensure the signal lead cannot be abraied through the insulation and short this critical lead to the base plate.
Car was very hard to start before but now starts on the button. Very easy to fit. Ignition timing did change significantly so do check the timing after fitment.