D10P-75 - Powerspark Lucas 59D Points Distributor with 1275cc Specific Advance Curve
The Lucas 59D distributor was used in the Mini from 1982 onwards in A Plus engines. It is is suitable for any vehicle that uses the Lucas 59D 4 Cylinder Distributor, such as the Austin Metro and Allegro, as well as some Morris vehicles.
Our 59D is available as points or electronic, with electronic variants being negative earth, positive earth, or High Energy (negative). This distributor is fitted with a vacuum advance, as it was from the factory.
All of our distributors have been developed to run on modern fuel, with a modern advance curve giving them a wide universal fitment.
The 998cc and 1275cc have an advance curve specifically developed to run well in those engines when used in a Mini or Metro.
We do offer a non-vac version of this distributor, which is suited to competition and track vehicles. See below for the complete list of 59D distributors that we offer.
With racing cars, optimum performance of the engine at high revs is more important than fuel economy or running while cold and under very little load, which is why a non-vac distributor is used. Without the vacuum components and weights, a non-vac distributor is less complicated to maintain and easier to time. Only use a non-vac distributor if you are certain that is what you require.
We offer this The Lucas 59D Points Distributor with Vacuum Advance in the following
We offer this The Lucas 59D Electronic Distributor with Vacuum Advance in the following combinations:
We offer this The Lucas 59D Electronic Distributor WITHOUT Vacuum Advance in the following combinations:
About the Powerspark range of distributors
Traditional Points Distributors:
The traditional ignition system used in most cars up until the 1980s.
- To be used with a Standard or Sports ignition coil, resistance reading above 1.4ohms. OK to use copper HT Leads
Standard Electronic Ignition Distributors:
Looks like an original points distributor but contains an electronic ignition module
- To be used with a Standard or Sports ignition coil, resistance reading above 1.4ohms. Not suitable for use with copper HT Leads
High Energy Electronic Ignition Distributors:
Looks like an original points distributor but contains an electronic ignition module capable of 3x the spark of standard electronic ignition.
- To be used with a Standard or Sports ignition coil, resistance reading less than 1.4ohm. Not suitable for use with copper HT Leads