D14 - Ford OHV Kent, Crossflow, Twin Cam Lucas 45D Distributor Electronic High Energy
The Lucas 45D Distributor was one of the most widely used distributors ever made, and we offer a number of replacements for this model including traditional points, standard electronic and high energy variants with either side or top entry distributor caps.
This item is a Powerspark 45D Top Entry Electronic Distributor. It contains a Powerspark electronic ignition module which will give you improved starting and reliability when compared to traditional points.
The Lucas 45D 4 Cylinder distributor was used in multiple vehicles from many manufacturers in the 1970s and 80s.
Ford used this distributor in the following vehicles:
Ford Cortina 1200, 1500 (1962-66)
Ford Cortina MKII 1300, 1500, 1600 (1967-70)
Ford Cortina MKIII 1300 (1970-76)
Ford Cortina MKIV, V 1300 (1976-83)
Ford Cortina 1500 GT (1962-66)
Ford Corsair (1963-65)
Ford Escort 1100, 1300,1600 (1968-76)
Ford Anglia 105E/123E (1968-76)
Ford Capri MKI, II, III 1300, 1600 (1968-81)
Ford Capri MKI, II 1600 (1968-72)
Ford Fiesta 1.0, 1.1 (1976-83)
Ford Capri Classic (1961-64)
We offer this distributor in the following combinations:
The original Ford Over Head Valve OHV three main bearing Kent engine arrived in 1959 with the then brand new Anglia 105.
It widely referred to as the pre-crossflow Kent or pre-crossflow, in reverse-flow cylinder head configuration with both the inlet and exhaust being on the same side of the head.
Cars that used the Pre-Crossflow engine are as follows:
Ford Consul Classic and Consul Capri.
107E Ford Prefect
Marcos 1500 GT
Otosan Anadol 1.2 L – 1.3 L (1966–1984)
The Pre-Crossflow Kent engine was also used by Lotus on Lotus Mk.VII.
In 1967 the Kent engine was redesigned to give it a cross-flow type cylinder head, hence the name Crossflow.
Cars that used the Crossflow engine are as follows:
Ford Cortina and Ford Capri
Ford Escort Mk1 and Mk2
Ford Cortina1.6 L Mk II, Mk III, Mk IV(South Africa Only)
Ford Cortina Mk5
Ford Sierra 1.6
Ford Fiesta MK1 1.3 and 1.6
The Ford Crossflow engine (1298 cc and 1599 cc) also powered the Reliant Anadol (1968–1984) and Morgan 4/4, Caterham 7, and TVR Grantura, Vixen, and 1600M.
It has since been used by countless kit-car builders all over the world.
Our Distributors and the Ford Crossflow / PreCrossflow / Kent Engine:
These engines used different distributors, and determining which one is in your car is not an exact science.
Variations for our Lucas distributors for Ford OHV Kent, Twin Cam and Crossflow distributors are as follows:
Lucas 23D Distributors for Ford and Lotus Twin Cam with Top Entry Cap NON VAC ADVANCE:
Ford Capri Mk2 1.3 1.6 3.0, Cortina 1970-76 1600, Escort Mk3 1.3,
Lucas 25D Distributors for Ford Engines AND Lotus Twin Cam Engines with Top Entry Cap:
Ford 105E and Cortina GT
Lucas 45D Distributors for Ford Engines with Top Entry Cap:
Lotus Elan (1962-74), Lotus Cortina (1963-66), Ford Escort Twin Cam (1968-70), Lotus Europa Type 74 (1975), Caterham Super 7 (1973-74), Mogran 4/4
Lucas 45D Distributors for Ford Engines with Side Entry Cap NON VAC ADVANCE:
Ford Capri MK2 1.3, 1.6, 2.0, Cortina 1970-75 1600, Escort M3 1.3
About Points, Electronic, High Energy and Positive Earth Distributors from Powerspark Ignition:
Traditional Points Distributors:
The traditional ignition system used in most cars up until the 1980s.
- To be used with a Standard or Sports ignition coil, resistance reading above 1.4ohms. OK to use copper HT Leads
Standard Electronic Ignition Distributors (often known as Sports Electronic):
Looks like an original points distributor but contains an electronic ignition module
- To be used with a Standard or Sports ignition coil, resistance reading above 1.4ohms. Not suitable for use with copper HT Leads
- Available as Negative Earth or Positive Earth for most of our distributors and ignition kits.
(If the product does not state whether it is Positive or Negative Earth in the listing then is Negative Earth.)
High Energy Electronic Ignition Distributors:
Looks like an original points distributor but contains an electronic ignition module capable of 3x the spark of standard electronic ignition.
- To be used with a Standard or Sports ignition coil, resistance reading less than 1.4ohm. Not suitable for use with copper HT Leads